Publicité
6.
Drill and deburr the hole, insert the
supplied grommet and route the cable for
the camera through the grommet in to
the vehicle. The grommet should always
be used, otherwise the sheet metal can
damage the cable.
7.
Localise the reversing lights on the
vehicle. Turn the ignition key to garage
mode, apply the parking brake and put
the vehicle in reverse to switch on the
reversing lights. Go behind the vehicle and
check where the reversing lights (white)
are. To localise the +12 V/+24 V wires to
the reversing lights you need access to the
back of the reversing lights. You may need
the wiring diagram to find the reversing
lights and suitable connection points –
contact the vehicle manufacturer.
8.
After finding a suitable connection point to
the reversing light circuit, route the cable to
this point. Carefully install and fix the cable,
making sure that it cannot chafe against or
fasten in any part of the vehicle, such as the
hinges for the boot. Never route the cable
on the outside of the vehicle.
9.
Two wires are connected to the reversing
lights in most vehicles. The negative wire
is usually black and the positive wire is
coloured. If in doubt, use a multimeter
or other suitable measuring instrument
to determine which wire is the positive
one. Use the multimeter in accordance
with the instructions of the instrument
manufacturer.
1. Camera
2. Cable
3. Red
4. Black
5. Reversing light
6. Positive (+)
7. Negative (-)
8. Slip on terminal
FIG. 6
10. When the polarity (positive and negative
wires) has been determined, switch off
the ignition and disconnect the negative
lead from the battery.
11. Connect the red wire to the positive wire
for the reversing light with the supplied
slip on terminal. Press in the tap on the
terminal with a pair of pliers to ensure
good electrical connection.
FIG. 7
12. Connect the black wire to the negative
wire for the reversing light or earth it to
the chassis.
13. Replace the bulb in the socket and refit
the socket. Carefully fasten all the wires
with insulating tape or cable ties.
14. Reconnect the negative lead to the
battery.
INSTALLATION OF MONITOR
IMPORTANT:
Install the monitor where it does not obstruct
the view when driving.
1.
Clean the surface before mounting the
monitor.
2.
Place the suction cup on a smooth surface
where the monitor can be easily seen.
3.
Press the suction cup against the smooth
surface and press down the locking lever
to lock it to the surface.
FIG. 8
4.
Click the monitor into the suction cup.
FIG. 9
5.
Adjust the arms of the suction cup so that
the monitor is at the right angle and lock
this position by tightening the screws.
FIG. 10
6.
Lead the monitor cable to the 12/24 V
socket, without it interfering with driving
the vehicle.
EN
31
Publicité
