Publicité
EN
Programming with code input
1.
Switch on the television to be controlled
with the remote control. Hold the remote
control in front of the television at distance
of no more than 1 metre.
2.
Press the buttons
control at the same time until the red light
goes on.
3.
Enter the 4-digit code for the television (see
Annex B).
4.
The light in the button
then goes out.
5.
Press the button
television switches off. If the television does
not switch off, repeat steps 2–4 above and
enter another of the 4-digit codes for the
television brand and try to switch it off again.
Repeat until the television switches off.
NOTE:
•
If there are several codes for television,
try the codes one by one and use the one
that controls the most functions on the
television.
•
If no buttons are pressed in 30 seconds
from when the red light in the button
goes on, or if something other than the
digit buttons is pressed, the light in the
button
goes out and the programming
process is interrupted.
Controlling the programming
When the remote control is programmed with
the correct code, check that the buttons control
the television functions correctly.
Correction
If one or more of the buttons do not control the
functions correctly they can be programmed
individually with the learn function.
26
and
on the remote
TV
flashes twice and
TV
and check that the
TV
Code programming with manual
search
1.
Switch on the television to be controlled
with the remote control. Hold the remote
control in front of the television at distance
of no more than 1 metre.
2.
Press the buttons
control at the same time until the red light
goes on.
3.
Press the button
the television switches off. The light in the
button
flashes once every time
TV
is pressed.
4.
When the television switches off the remote
control has found the correct code for the
television.
5.
Press the button OK to store the code. The
light in the button
NOTE:
•
In step 3
or
television switches off.
•
Release the button immediately when the
television switches off, otherwise the
remote control will continue with the next
code.
•
Press the button
to search back in the remote control's
code list. It can take several minutes to
browse through all of the remote control's
code list. The search function stops
automatically when all of the code list has
been browsed.
Controlling the programming
When the remote control is programmed with
the correct code, check that the buttons control
the television functions correctly.
and
on the remote
TV
or
repeatedly until
or
goes out.
TV
can be pressed until the
to search forward and
Publicité
