Hilti TE 2000-AVR Mode D'emploi page 23

1.Remove the supply cord from the cardboard box.
2.Plug the connector into the tool, pushing it in until it is heard to engage.
3.Plug the supply cord into the power outlet.
Fitting the accessory tool
1.Unplug the supply cord from the power outlet.
2.Lightly grease the connection end of the accessory tool.
▶
Use only the recommended grease supplied by Hilti. Using the wrong grease can result in
damage to the tool.
3.Push the accessory tool into the chuck as far as it will go, turning it and applying light pressure
until it engages with an audible click.
4.Check that the chisel has engaged correctly by gripping and pulling it.
Removing the accessory tool
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶
Wear protective gloves when changing the accessory tool.
▶
Never lay down a hot accessory tool on a flammable surface.
1.Unplug the supply cord from the power outlet.
2.Pull the tool lock back as far as it will go.
3.Remove the accessory tool.
Types of work
WARNING
Risk of electric shock! Severe injury and burns can result if any attempt is made to operate the tool
without an earth/ground conductor and ground fault circuit interrupter correctly connected.
▶
Irrespective of whether mains power or generator power is used, always make sure that an
earth/ground conductor and ground fault circuit interrupter are present in the power supply and
that these are correctly connected.
▶
Do not use the product unless these safety measures are in place and fully operational.
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if
damaged while working. Disconnect the supply cord plug from the power outlet.
▶
Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist
if found to be damaged.
Full approval must be obtained from the site engineer or architect prior to beginning the work.
Chiseling
1.Plug the supply cord into the power outlet.
2.Position the tip of the chisel at the desired location.
3.Press the on/off switch.
Working at low temperatures:
The hammering mechanism works only when the power tool has reached a minimum operating
temperature. Bring the chisel into contact with the workpiece and allow the power tool to run
under no load until the required temperature is reached. If necessary, repeat this procedure
until the hammering mechanism begins to operate.
Switching off
1.Press the on/off switch.
2.Unplug the supply cord from the power outlet.
*2154380*
4
5
2154380 16