Hilti TE 2000-AVR Mode D'emploi page 22

When powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the power tool. The operating
voltage of the transformer or generator must always be within +5% and -15% of the rated voltage of
the power tool.
Product generation
Weight in accordance with EPTA procedure 01
Impact speed
Protection class
Noise information and vibration values
The sound pressure and vibration values given in these instructions were measured in accordance
with a standardized test and can be used to compare one power tool with another. They can also be
used for a preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used
for different applications, with different accessory tools, or is poorly maintained, the data can vary.
This can significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is
switched off, or when it is running but not actually being used for a job. This can significantly reduce
exposure over the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration,
for example: maintaining the power tool and accessory tools, keeping the hands warm, organization
of work patterns.
Detailed information on the versions of the EN 62841 standards applied here is to be found in
the reproduction of the declaration of conformity
Noise emission values
Measured sound power level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration values
Chiseling (a )
h, Cheq
Uncertainty (K)
Operation
Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶
Unplug the supply cord before making adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
Connecting the supply cord to the power tool
The releasable plug connector may be connected to the product only when it is clean and dry
and when under no voltage (i.e. disconnected from the electric supply). The plug connector has
a keyed fit.
15
TE 2000­AVR
01
14.5 kg
30 Hz
II
) 96 dB(A)
WA
3 dB(A)
)
WA
) 88 dB(A)
pA
) 3 dB(A)
pA
3.9 m/s²
1.5 m/s²
3
180.
2154380
*2154380*