Télécharger Imprimer la page

OBSIDIAN CONTROL SYSTEMS EN5D Guide D'installation Et D'utilisation page 23

Publicité

M E N U : S Y S T E M
This menu contains all the settings to configure and manage the
device.
SUB MENU
Device Namel NETRON EN6D
Device ID
0-999
Display Timeout
Screen Brightness 1-10
LED Brightness
Display
Home Screen
Universe 1:0-0
Art-Net Offset
Universe 1:0-1
PIN : 000-999
Lock Device
Confirm
Cue
Start up
Wait For Data
Send 0
Hold Last Lock
Signal Loss
Fade to 0
Cue
Disable DMX
Save Config
Backup Config
Load Config
All Disable
RDM
Processing
All Enable
Pin000-999
Factory Reset
Confirm
OPTIONS / VALUES
Disable, 10s, 30s, 1m,
5m, 10m
0-10
Devicer Info
Cue Browser
Universe Browser
PIN (011)
Lock:Disable/Timeout
Manual Lock
0-60Min,Forever
0-60Sec
PIN (011)
M M E E N N U U
DESCRIPTION
Set a device name.
Set an optional device ID.
Display stays on indefinitely.
Display goes dark after this time.
Adjust the brightness of the internal display.
Adjust the brightness of the front LEDs. Set to 0 to
disable them.
The display shows port and connectivity information.
The display shows a list of stored cues which can easily
be browsed and started by the encoder wheel.
View and select DMX universes from the home screen.
Universe 1 is sent to Art-Net 0-0.
Universe 1 is sent to Art-Net 0-1.
The device does not require a pin.
Lock the device immediately.
Run a specific Cue at startup.
No DMX is sent until valid data is received for the
ports. The last incoming values continue to be sent
on the ports until the time is expired. Once timeout
has completed the device will perform one of the
below actions.
The last incoming values continue to be sent on the ports
until the time is expired. Once timeout has completed
the device will perform one of the below actions.
Crossfade to DMX 0. Set to 0s for instant out.
Start Cue X
DMX traffic is turned off on all ports.
Save current configuration including all cue data.
Reload configuration. Backups can be exported and
imported from the web interface.
Disables RDM processing on the device.
Enables all RDM processing on the device.
Reset the device to factory default. It will reload
NETRON Preset 1. All cues are deleted, and all
settings are set to default.
23
V V i i e e w w a a n n d d T T e e s s t t
I I P P A A d d d d r r e e s s s s
E E m m e e r r g g e e n n c c y y K K e e y y
S S y y s s t t e e m m
I I P P X X . . X X X X X X . . X X X X X X . . X X X X X X

Publicité

loading