Publicité
3.4 Levelling
When placing the appliance make sure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
3.5 Door reversibility
WARNING!
Before carrying out any operations,
remove the plug from the power socket.
1. Make sure the appliance stands upright.
2. Open the door and remove the door
equipment. Refer to the "Daily use"
chapter. Close the door.
3. Unscrew the screws on the back of the
top cover.
4. Lift the top cover and place it on a soft
surface.
5. Unscrew the 4 screws that connect the
upper hinge. Put the upper hinge in a
safe place together with the screws.
6. Lift the door and put it on a soft surface.
7. Tilt the appliance carefully on a soft foam
packaging or similar material to avoid any
damage to the back of the appliance and
the floor.
8. Unscrew the screws of the bottom hinge
and adjustable feet.
9. Install the pin in the opposite hole of the
hinge.
10. Screw the bottom hinge on the other side
of the appliance.
11. Install the rubber support on the side with
no hinge.
12. Fit the door on the lower hinge making
sure the hinge pin enters the door bottom
hole.
13. Install the upper hinge on the opposite
side of the appliance. Fit the upper hinge
pin into the door upper hole. Tighten the
screws.
14. Screw the remaining 2 screws on the top
side of the appliance with no hinge.
15. Place the top cover on the appliance and
tighten the screws on the back.
ENGLISH
73
Publicité
