Shop-Vac SC16 Serie Manuel D'utilisation page 12

STORAGE (CONT'D.)
3. The hose may be stored in the hose holder. To do this place one end of the hose
between the hose holder posts and the tank cover. Wrap the hose around the tank
cover keeping the hose tucked between the posts and the cover.
4. Accessories may be stored in the accessory caddy. The vacuum should be stored
indoors.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES
Loss of suction or
1. Clogged filter
cleaner runs hot
2. Full tank
3. Air Leak
4. Hole in hose
5. Obstruction in hose or
accessory
Dust discharging
1. Filter not properly
from tank cover
installed
2. Filter damaged
3. Dust too fine for filter
Mist discharging 1. Saturated filter
from tank cover
2. Full tank
1. Power cord not plugged into
Will not start
outlet
2. No power at the outlet
3. Defective switch or motor
WARNING
BECOME DETACHED OR BROKEN, EXPOSING THE MOTOR OR ANY OTHER ELECTRICAL
COMPONENTS, OPERATION SHOULD BE DISCONTINUED IMMEDIATELY TO AVOID
PERSONAL INJURY OR FURTHER DAMAGE TO THE VACUUM. REPAIRS SHOULD BE MADE
BEFORE REUSING THE VACUUM.
–
IF ANY OF THE MOTOR HOUSING PARTS SHOULD
SOLUTION
1. Clean or replace filter
2. Empty tank
3. Tighten hose and accessory
connections
4. Replace hose
5. Remove obstruction
1. Properly install filter
2. Replace filter
3. Add a high efficiency
disposable filter bag
1. Allow filter to dry or replace
with dry filter
2. Empty Tank
1. Plug cord into outlet
2. Plug cord into another outlet
3. Contact Shop-Vac
®
customer service
PAGE 11