Publicité
2. Using a screwdriver, remove the screw holding on the
front grill. Lift grill upwards and pull away from unit to
remove. Set aside the grill.
Note: Re-install the front grill after placing the freezer in the
desired location and tighten the screw with a screwdriver.
3. Remove bolts (4) holding the unit to the pallet using the
7/16" wrench.
CAUTION: Always be cautious to not damage or
drop the unit when lifting the unit with forklift.
4. Carefully position forks to lift unit from rear. Ensure unit is
fully positioned on fork truck prior to raising the forks.
5. For single door units: Raise the unit approximately six
inches to allow access to the feet and casters.
Person 1: Stand at the front of the unit and provide
additional support to the unit. Person 2: If Leg Levelers
are desired, lower all 4 factory installed Leg Levelers
(using the 3/8" wrench to loosen if necessary). If rolling
casters are desired, remove the feet and install the 4
casters and tighten using wrench.
6. For double door units: Raise the unit approximately six
inches to allow access to the Leg Levelers.
Person 1: Stand at the front of the unit and provide
additional support to the unit.
Person 2: If Leg Levelers are desired, lower all 4 factory
installed Leg Levelers. For casters, remove the 8 Hex
Head Bolts, 8 Nuts and 8 Washers fitted with levers using
the wrench and keep aside (to be re-used to mount
casters).
6a. Remove the 4 leg levelers and discard or save for
future use.
6b. Install the 2 casters with lock in the front of the
cabinet with 8 sets of 5/16-18x1" Hex Head Bolts,
General Purpose Freezers
5/16" Nuts and 7/8" O.D. washer, supplied with the
package 4 sets of (2) 5/16-18 x 1 Hex Head Bolts,
Nuts.
6c. Re-use the 8 sets of 5/16-18x1" Hex Head Bolts, 5/
16" Nuts and 7/8" O.D. washer to install the 2 casters
without lock in the rear of the cabinet.
Note: Some casters lock and others do not. It is advised to
install the locking casters on the front of the unit.
7. Remove pallet from below the unit and gently lower unit
in desired location.
Figure 1. Caster Installation
DANGER : Do not tip unit more than 10 degrees
during caster installation. Overturning may result
in serious injury or death.
Table 4. Caster Installation Spar
S. No.
Parts
5/16-18x1" Hex Head Bolts
1
(8 supplied with kit, 8 re-used)
5/16" Nuts
2
(8 supplied with kit, 8 re-used)
7/8" O.D. washer
3
(8 supplied with kit, 8 re-used)
Caster with Lock (2 in the front)
4
Caster without Lock (2 in the rear)
5
e Parts
Installation |
7
Publicité
