Husqvarna TS 300 E Manuel D'utilisation page 6

Note: Setting the TS 300 E for a 350 Ø disk
Warning: the setting procedure described is for an uninstalled disk.
1- Slide the cables through the plastic collar attached to the arm
of the TS 300E. Be careful to keep electric cables and water
hose clear of the setting screw located at the back.
3- Tilt the head of the machine to clear the centering pin.
5- Insert the head spindle into upper hole of the TS 300E.
Warning: always check that the head spindle is inserted into the right hole
Please make sure that the electric cables do not get pinched or caught.
(Factory setting is 300 Ø)
for the disk used
(lower hole for 300 Ø; upper hole for 350 Ø).
2- Remove the nut and washer with the 30 mm wrench (UK
spanner) provided.
4- Remove the head by pulling it toward the front to clear the
axis of the head from the lower arm hole of the TS300E.
6-Insert the centering pin into the housing. Hold the head
horizontally and put back the washer and nut with the 30 mm
wrench (UK spanner)