Publicité
5. Insert the Eyeball Seat into the Outlet Holder that
is fixed into the glass. This part is a tight fit so that
it will not float out during any pump maintenance
but can be removed if necessary for cleaning.
6. Insert the Eyeball outlet followed by the seal into
the Outlet Holder.
7. Lower the pump into the pump chamber until the
Outlet Elbow with the Bayonet connector is opposite
the Outlet Holder.
8. Screw the Bayonet to the Holder until firmly in
position. Check that the Eyeball is free to rotate but
held securely in the desired position. Initially adjust
the nozzle to the downward position to prevent
splashing when the pump is first switched on.
9. Feed the cable over the back wall and connect to
the right hand cable of the Pump Switch Box by
tightening the connector nut.
10. With the circulation pump secured in position, push
the black filter sponge into the pump chamber so
that the slit in the sponge is in line with the flexible
pipe.
6.6 Sump Screen:
Position the sump screen above the front wall of the rear sump. Align the
hinges above the clips on the top of the side walls and push firmly into
position. Push the rear of the sump screen until it clicks into position.
To rotate, pull the top of the screen forward until the screen lays flat on
the top of the tank.
ENG
15
Publicité
