Publicité
Red Sea MAX
®
NANO G2
6.4 Carbon:
Wash the carbon filter material under running water several times to
remove residual dust. It is recommended to soak it in water for 24-72 hrs.
before usage otherwise during the first 3 days after set-up the carbon
may float and release micro air bubbles from inside its pores.
Lower the washed carbon into the chamber to the right of the skimmer
so that it rests on the grid located approximately 30cm (12") below the
top surface of the glass. Close the Media retainer to prevent the carbon
from floating upwards.
14
6.5 Circulation Pumps:
Familiarize yourself with the multidirectional outlet as shown in the
drawing. Familiarize yourself with the circulation pump by disassembling
and reassembling all of the component parts. Ensure that the impeller
chamber cover is correctly positioned and properly secured by the
bayonet ring and that the flow valve is in
the fully open position. Screw the hose barb
provided into the outlet of the pump.
1. Before use, check that the pump and
power cable are not damaged.
2. Push the rubber feet inlet on the pump
and screw the hose barb into thr outlet.
3. Thread the outlet
bayonet connector onto
the flexible pipe and
assemble the flexible
pipe to the pump so
that the outlet elbow
is perpendicular to the
pump as shown in the
drawing.
4. Wrap the power cable
around the pump as
shown and attach to the
flexible pipe with the
cable ties provided.
X2
Publicité
