Publicité
thus avoiding the wetting of the ironing board
or surface on which you are ironing.
How to clean limescale using the "Calc
Cleaning" cycle:
- Fill the tank halfway with water.
- Make sure the machine is on.
- Position
the
temperature
maximum value.
- Keep the ON/OFF switch ( ) pressed until
the appliance emits a triple beep (for at least
7 seconds), release the switch;
- Place the iron above the receptacle/bowl
1
and press the steam activator on the iron to
begin the cleaning cycle;
- During the cleaning cycle, the LED light
flashes blue; hot water, steam and limescale
particles will come out from the iron. The
cleaning cycle takes approximately 1 minute,
do not interrupt the flow until it is complete.
- At the end of the complete cleaning cycle,
the triple beep indicates that the procedure
has finished and the blue indicator light
around the iron will stop flashing.
- After having run the Calc Cleaning procedure,
residual water may leak from the plate.
- Dry the iron with a cloth.
WARNING:
The
iron
temperature depends on the dial position.
- You may now resume normal ironing.
If for any reason you decide to end the
cleaning cycle before it finishes, keep the ON/
OFF BUTTON ( ) pressed (for at least 7
seconds) until the appliance emits a triple
beep. Cleaning will be interrupted and the
blue LED light will stop flashing.
10. GENERAL MAINTENANCE
Except when running the Calc Cleaning cycle,
always unplug the appliance from the power
mains before conducting any maintenance
upon it, making sure that the product has
cooled down before proceeding.
To clean the outside of the appliance, only use
a damp cloth.
Do not use detergents of any kind.
Clean the iron soleplate when it is completely
cold with a damp cloth or with a non-abrasive
sponge.
dial
on
2
is
hot
and
11. STORAGE
11.1
Turn off the appliance and disconnect
from the mains electricity.
11.2 Wait for the appliance to cool down
completely before storing it.
11.3 Empty the water tank.
11.4 Place the iron onto the mat, securing it
the
with the special locking button on the front of
the appliance (11). Press the button to unlock
it
(12).
11.5 Place the power cable and water hose in
their special housing (13).
its
| 12 |
Publicité
