Publicité
Clutch Adjustment:
•
The friction clutch system is adjusted at the factory prior to shipment.
•
Under normal conditions it should perform without any adjustment for well over 1000 working hours.
•
If it is noted that the clutch is slipping with minimal loads, even though the green power cord is fully
pulled, so the clutch arm rests against the stop, then a clutch adjustment may be necessary.
Procedure for adjusting the clutch
IMPORTANT: REMOVE THE PTO FROM THE WINCH
Loosen Nut "A" and Nut "B" as show in Fig. B above, Never loosen Nut "C" unless your
1.
dismantling the main cable drum shaft. (This is to be done by an authorized dealer only)
2.
Pull the Green Pull Cord until the clutch cam lever (p/no 15504) rests against the stop and hold
the pressure on the clutch
Tighten bolts "A" &"B" until a resistance is met. Then release the Green pull Cord.
3.
Tighten bolts "A" & "B" an additional ¾" turn each
4.
Tighten nuts "A" &"B". Install and engage the PTO shaft, and the winch is now ready to operate
5.
Nut A
Bolt A
Nut C
Never loosen
Nut B
Bolt B
Fig. B
16
Publicité
