Ryobi ERH850RS Manuel D'utilisation page 5

GB
FR DE ES
DESCRIPTION
1. Locking collar
2. Variable switch with reverse action
3. Lock-on button
4. Auxiliary handle
5. Depth stop
6. Mode selector
7. Live tool indicator
8. Hammer mode
9. Hammer drill mode
10. Drill mode
SPECIAL SAFETY RULES
Wear ear protectors. Exposure to noise can cause
hearing loss.
Use auxiliary handles supplied with the tool. Loss
of control can cause personal injury.
Wear goggles and use a dust mask on jobs
generating dust.
Hold power tool by insulated gripping surfaces
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
SAFETY PRECAUTIONS
When using electric tools, basic safety precautions
should always be followed to reduce the risk of ¿ re,
electric shock and personal injury. Before you use your
tool, read these instructions carefully and make sure that
you understand them thoroughly.
Make sure that the supply voltage (Volts) used
corresponds to the voltage marked on the tool's rating
plate.
When using cable drums, run all the cable off the
drum. Minimum cable across section: 1.0 mm.
When using the electric hammer drill outdoors,
connect it to an outdoor-grade extension cable type
H07RN-F 2G, 1.0 mm and rain-water-protected plugs
in proper working order.
Make sure of your footing when drilling freehand.
Before drilling, use a line detector to locate concealed
electric, water or gas lines in walls. Avoid touching live
components or conductors.
Wear goggles and use a dust mask on jobs generating
dust.
IT NL PT DK SE
IMPORTANT
FI NO RU PL CZ
English
Wear ear protectors. Exposure to noise can cause
hearing loss.
Do not use your hammer drill near flammable liquids
or gases.
Always pull the plug out of the socket before cleaning
your tool or changing accessories.
Keep the power cable in good condition. Oil and acid
can damage the cable.
Never overload the tool.
Make sure your workplace is safe.
It is imperative to follow all national safety regulations
concerning installation, operation and maintenance of
the tool.
If incorrectly fitted, chisel bits and drill bits may be
flung out of the tool accidentally and cause serious
injury. Before you start using your hammer drill, always
check that the chisel or drill bit is properly locked in
the chuck.
Examine the chuck regularly for signs of wear or
damage.
Always press the hammer drill against the work
surface (wall, ceiling, etc.) before you start it.
When you are finished, unplug the hammer drill from
the power supply and remove the chisel or drill bit.
Always disconnect the hammer drill from the power
supply before you change the chisel or drill bit.
Wear safety goggles to protect your eyes from flying
particles and splinters. Have other workers do the
same. Wear a helmet and put up partition walls in your
work place!
Wear work gloves to protect fingers from bruising and
grazing.
Vibrations can injure the hand/arm. Keep exposure to
vibrations as short as possible.
Always keep the power cord behind the tool.
Store the tool out of the reach of children.
When using the tool, always hold it with both hands
and ensure that you have stable footing.
SPECIFICATIONS
Voltage
Power consumption
1
HU RO LV LT EE
IMPORTANT
230 V - 240 V
850 W
HR SI SK GR TR
50 Hz