Publicité
OPERATION
PREPARATION
1. CHECKING CONNECTIONS
• Make sure that all the connections are proper by referring to
the back panel. (Fig. 2~3)
• Check the polarity (positive and negative) of connections, and
the directivity of stereo separation (right cord to right channel
terminal, and left cord to left channel terminal).
• Check the directivity of pin cord connection.
2. SETTING OF EACH KNOB
• Turn the volume control knob
• Set the rotary knob to "flat" or "center position".
r
• Set SOURCE DIRECT
to "OFF (
• Press the TAPE MONITOR switch
• Turn on the speaker selection switch for desired speaker
system (A or B).
After checking the above items, turn on the power, the amplifier is
set in the ready mode in a few seconds.
PLAYING A RECORD
1. Set the INPUT SELECTOR switch
2. Operate the turntable and play the record.
3. Turn the volume and tone controls to yield an appropriate volume
and sound quality.
PLAYBACK OF CD PLAYER
1. Set the INPUT SELECTOR switch
2. Operate the CD player.
3. Turn the volume and tone controls to yield an appropriate volume
and sound quality.
RECEPTION OF RADIO PROGRAMS
1. Set the INPUT SELECTOR switch
2. Operate the tuner to receive a radio program.
3. Turn the volume and tone controls to yield an appropriate volume
and sound quality.
CONNECTIONS OF AUDIO EQUIPMENT TO AUX
TERMINALS
1. Set the INPUT SELECTOR switch
2. Operate the Audio equipment Systems.
3. Turn the volume and tone controls to yield an appropriate volume
and sound quality.
PLAYBACK WITH TAPE DECK
1. Set the TAPE MONITOR switch
"TAPE-2/MD".
2. Operate the Tape Deck.
3. Turn the volume and tone controls to yield an appropriate volume
and sound quality.
RECORDING WITH TAPE DECK
The source to be recorded is selected by the INPUT SELECTOR
!3
switch
.
COPYING FROM ONE TAPE TO ANOTHER
To copy from COPY/TAPE-1/CD-R to TAPE-2/MD, press the
!2
COPY/TAPE-1/CD-R switch
.
NOTE:
Copying is not possible from TAPE-2/MD to COPY/TAPE-1/CD-R.
t
counterclockwise, to left.
)".
£
!2
to turn the LED off.
!3
to "PHONO".
!3
to "CD".
!3
to "TUNER".
!3
to "AUX" Position.
!2
to "COPY/TAPE-1/CD-R" or
MONITORING THE RECORDING
(If a 3-head tape deck is used, the sound being recorded can be
monitored during the recording.)
Use the TAPE MONITOR switches
which the sound is being recorded.
The LED for the selected tape deck lights.
CAUTION
Protective Circuit
This set is equipped with a high speed protective circuit. This
circuit protects the internal circuitry from damage due to large
currents flowing when the speaker jacks are not completely
connected or when an output is generated by a short circuit.
This protective circuit's operation cuts off the output to the
speakers. In such a case, be sure to turn the power to the set
off and check the connections to the speakers. Then turn the
power on again. After muting for a few seconds, the set will
operate normally.
ENGLISH
!2
to select the tape deck onto
11
Publicité
