Publicité
GB
MT
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Engine is slowing down and
stops
Device works with interrup-
tions
Milling progresses unevenly Parallel guide (20) not inser-
Workpiece has burn marks
Edges of the milling tear out
Grooves and unevenness in
the milled surface
Dust is not extracted
Spare parts and accessories
You can get spare parts and accessories from www.grizzlytools.shop. If
you have any problems with your order, contact us via our online shop. If you have any
other questions, contact the Service Centre, p. 34
Pos. nr. Name
9
Collet chuck, 8 mm
13
Depth stop
15
Power cord
32
Possible cause
No mains power supply
On/Off switch (3) is broken contact the service centre.
Defective motor
Device is overloaded through
workpiece
Internal loose contact
On/Off switch (3) is broken
ted
Unsuitable or blunt cutter
Milling depth is too large
Cutter is worn and diffuse
Cutter blades are damaged
Vacuum cleaner not switched
on
Suction hose or adaptor
for external dust extraction
blocked
Error correction
Check the socket, mains con-
nection cable, plug and fuse
and have them repaired by a
qualified electrician if neces-
sary.
contact the service centre.
Reduce pressure on attach-
ment tool
Workpiece unsuitable
contact the service centre.
Fitting and removing the par-
allel guide, p. 27
Change the cutter
Setting the milling depth,
p. 28
Change the cutter
Switch on vacuum cleaner
before milling
Removing obstructions and
blockages
Order No.
91104911
91104936
91104939
Publicité
