Publicité
Before
use
if,
=i
ROT4880 |
Adhesive tape
FM indoor antenna
©
N Antenna holder
R
1
Ch" loop antenna
it
Connections
Plug the AC power cord into a household AC outlet only after all
other connections have been made.
®To prepare the AM loop antenna wire and speaker cords, twist the
vinyl cover tip and pull off.
eFor your listening pleasure, keep your speakers from touching the
system.
These speakers are designed identically so that no left or right
channel orientation is necessary.
e You can take the front net off these speakers.
Connect the FM indoor antenna.
Tape the antenna to a wall or column, in a position where radio
signals are received with the least amount of interference.
For best reception sound:
An FM outdoor antenna is recommended. (= page 7)
Connect the AM loop antenna.
After attaching the antenna, turn on the system and tune in a
broadcast station. Then, turn the antenna to the angle of best
reception and least interference.
(D Connect the right (R) and left (L) speaker
cords (pin type).
@ Connect the right (R) and left (L) speaker ca-
bles.
Keep your speakers at least 10 mm ('%/s2") away from the sys-
tem for proper ventilation.
eTo prevent damage to circuitry, never short-circuit positive (+)
and negative (—} speaker wires.
eBe sure to connect only positive (red) wires to positive (+) ter-
minals and negative (black) wires to negative (—) terminals.
Caution
Use the speakers
only with the recom-
mended system. Failure to do so may lead
to damage
to the amplifier
and/or
the
speakers, and may result in the risk of fire.
Consult
a
qualified
service
person
if
damage has occurred or if you experience
a sudden change in performance.
a Connect the AC power cord.
Publicité
