Publicité
1. Inadequate air supply.
Tool does not
operate well:
2. Inadequate lubrication.
can
not
3. Worn or damaged O-rings or
drive fastener
seals.
or
operate
4. Exhaust port in cylinder head
sluggishly.
is blocked.
1. Worn bumper or damaged
spring.
2. Dirt in front plate.
3. Dirt or damage prevents
Tool skips
fasteners from moving freely in
fasteners.
magazine.
4. Worn or dry O-ring on piston or lack of
Lubrication.
leaking.
1. Incorrect or damaged
fasteners.
2. Damaged or worn driver
Tool jams.
guide.
3. Magazine or nose screw
loose.
4. Magazine is dirty.
5. Cylinder covers seal
- 13 -
1. Verify adequate air supply.
2. Place 2 or 6 drops of oil into
air inlet. 3. Check and replace
O-rings or seal.
damaged internal parts.
1. Replace bumper or pusher
spring.
2. Clean drive channel on front
plate.
3. Magazine needs to be
cleaned.
4. O- ring needs to be
replaced.And lubricate.
5. Replace Sealing washer.
1. Change and use correct
fastener.
2. Check and replace the
driver.
3. Tighten the magazine.
4. Clean the magazine.
4. Replace
Publicité
