Publicité
4.2 Connection to the compressed air system
Ensure that the pressure supplied by the compressed air system does not exceed
the maximum allowable pressure of the fastener driving tool. Set the air pressure
initially to the lower value of the recommended allowable pressure (see
TECHNICAL DATA).
Empty the magazine to prevent a fastener from being ejected at the next stage of
work in the event that internal parts of the fastener driving tool are not in the
starting position following maintenance and repair work or transportation.
Connect the fastener driving tool to the compressed air supply using suitable
pressure hose equipped with quick-action connectors.
Check for proper functioning by applying the muzzle of the fastener driving tool to
a piece of wood or wooden material and actuating the trigger once or twice.
4.3Filling the magazine
Only those fasteners specified under TECHNICAL DATA (see 1.1) may be used
When filling the magazine, hold the tool so that the muzzle is not pointing towards
the operator or any other person or animals.
4.4 Handling the tool
Pay attention to 2-Special Reference-of these operating instructions.
Having checked that the fastener driving tool is functioning correctly, apply the tool
to a work piece and actuate the trigger.
Check whether the fastener has been driven into the work piece in accordance
with the requirements.
- if the fastener is protruding, increase the air pressure in increments of 0.5 bar,
checking the result after each new adjustment;
- if the fastener is driven into an excessive depth reduce the air pressure I
increments of 0.5 bar until the result is satisfactory.
You should endeavor in any event to work with the lowest possible air pressure.
This will give you three significant advantages;
1. Energy will be saved,
2. Less noise will be produced,
3.A reduction in fastener driving tool wear will be achieved.
Avoid triggering the fastener driving tool if the magazine is empty.
- 10 -
Publicité
