Publicité
6 Troubleshooting (See Table 1)
SYMPTOM
Air
leak
near
top
of tool or in
trigger area
Air leak near
bottom of tool.
Air leak
between body
and cylinder
cap.
Blade driving
fastener too
deep.
PROBLEM
1. O-ring in trigger valve is
damaged.
2. Trigger valve head are
damage.
3. Trigger valve stem, seal or
O-ring are damaged.
1. Loose screws.
2. Worn or damaged O-rings or
bumper.
1. Loose screws.
2. Worn or damaged O-rings or
seals.
1. Worn bumper.
2. Air pressure is too high.
SOLUTIONS
1. Check and replace O-ring.
2. Check and replace.
3. Check and replace trigger valve
stem, seal or O-ring
1. Tighten screws.
2. Check and replace O-rings
or bumper.
1. Tighten screw.
2. Check and replace O-rings
or bumper.
1. Replace bumper.
2. Adjust the air pressure.
- 12 -
Publicité
