Hkoenig V6 Manuel D'utilisation page 11

continue happen for more than 60 seconds, please check whether water tank and filter
assembled correctly or not
a. When set selection button at "NYLON" position, no steam escaped since it only just suits for
dry ironing.
When set fabric setting at "POLYESTER" / "RAYON" / "COTION"
b.
"LINEN" ,steam willautomatically vary according to sole-plate temperature. Pump will stop
working and no steam escaped when sole-plate temperature decrease too low.lt will resume
after reheated to desiredtemperature.
Dry ironing
1.
Connect the appliance to a suitable socket outlet, lay handle down. Power indicator light
(red} "<!) "on iron unit light up ,it indicates that the unit has been connected to power supply.
2. Set selection button to desired position according to above fabric setting chart. Blue indicator
light at iron unit blinks slowly to indicate the unit being heated up. When the blue indicator light
change to light up steadily and an audible "Bi" signal produced, the desired temperature has
been reached. During use, blue indicator light will cycle from blinking to light on steadily, and
then from steady mode to On. lt does not indicate a defects or hazard, it is just because the
appliance are temperature constant.
3. After use, put iron unit back onto the base unit again, turn selection button to" <!) ",and
then unplug the appliance from main socket .
Note: When changing your Temp setting from higher setting to lower, it is proposed that not
to start ironing immediately since it may cause burns to your fabrics. Please wait till blue
indicator light lights up steadily, and then start ironing.
Vertical steam ironing
Follow the steam ironing process, and then hold the iron in vertical position between 5cm and
15cm away from the hanged fabrics. Press down steam switch, this will create vertical steam. This
feature is especially used for removing creases from hanging clothes and curtains. Never directly
perform steam ironing on people.
Auto shut off function
The appliance willcorne intoauto shut off modealong with audible "Bi..." signal when ithas been used for 60
minutes continuously with temperatureset atany settings, power indicator light" c!)"Blink. Press selection
button to reset another 60 minutes cycle if continuous use is necessary.(Note:once each setting is
pressed,the unit will reset time)