Publicité
SAFETY INSTRUCTIONS
•
Helmet for pedal cyclists, skateboarders or
roller skaters.
•
The helmet is not intended and does not
provide adequate protection for motor
sports, riding a moped, or other vehicles.
•
To provide full protection the helmet must
be properly fitted and the straps and clasps
must be correctly tensioned and fastened.
•
No helmet can provide full protection from
head injuries. Accidents at low speed can
also lead to serious or fatal head injuries,
depending on the force of impact.
•
The helmet is designed to absorb the
force of impact, either by deformation
and/or destruction. Even if there is no
visible damage after a fall the helmet
should be immediately discarded and
replaced with a new one.
•
Do not expose the helmet to heat. The
helmet will be damaged if exposed to
temperatures over 65°C. This temperature
can be exceeded in dark vehicles and
storage cases during very hot weather. Heat
deforms helmets and blisters the surface
structure. Discard a damaged helmet
immediately and replace it with a new one.
•
Do not modify the helmet or remove
any of the original parts, unless this is
specifically recommended by the
manufacturer.
•
The helmet must not be adapted, or fitted
with accessories not recommended by the
manufacturer.
•
Solvents, paint and/or stickers can damage
the helmet and prevent it from providing
proper protection during an accident.
•
Exercise due care and attention during all
activities that involve using the helmet, and
read the instructions carefully before use.
WARNING!
This helmet should not be used by children
while climbing or doing other activities when
there is a risk of strangulation/hanging if the
child gets trapped with the helmet.
TYPE APPROVAL
This helmet is designed to protect impact
cause by collision of head with an obstacle
while cycling or roller skating, it has passed
EN1078:2012+A1:2012 to show conformity to
the EHSR of Regulation (EU) 2016/425.
The product has been type approved by the
accredited testing institute
NB 2443
TUV SUD DANMARK ApS
Strandvejen 125, 2900 Hellerup, Denmark
SYMBOLS
Approved as per
applicable directives.
DESCRIPTION
PROTECTION AND VENTILATION
The outer shell makes the helmet very
lightweight, durable and robust. The
ventilation openings and inner air channels
allow air to flow over the forehead and under
the helmet for maximum cooling.
A. Back
B. Front
1. Strap 2
2. Strap 1
3. Back strap
4. Chin strap
5. Lock ring
FIG. 1
A. Front
1. Chin strap
2.
Strap tensioner
3. Clasp
4. Back strap
FIG. 2
EN
1
Publicité
