Publicité
STEP 5
INSTALL GEOTEXTILE AND LINER
• Install Outer Geotextile – Lay the geotextile into the
excavation, covering the bottom and sides (Ex. 6). Multiple
sections of geotextile can be overlapped to accomplish
complete coverage.
• Install Liner – Lay the liner into the excavation and position
to cover entire storage basin (Ex. 7). Do not trim the
excess liner material until later in the project.
• Optional Inner Geotextile – An optional second layer of
geotextile may be used within the lined storage basin. The
second layer is wrapped around the bottom and sides
of the AquaBlox, helping further protect the liner from
the edges of the AquaBlox. The secondary inner layer of
geotextile is especially useful protection on bigger storage
basins that contain a larger quantity of AquaBlox.
STEP 6
INSTALL PONDLESS
WATERFALL VAULT
• Place the Pondless Waterfall
Vault into its proper location
(Ex. 8).
6
STEP 7
INSTALL AQUABLOX
• Install AquaBlox in the storage basin, butting them
tightly against each other (Ex. 9). After placement of the
AquaBlox, bring the optional inner geotextile (if using) up
the sides of the tanks.
Ex. 6
AQUABLOX ORIENTATION
• The AquaBlox must be installed with the correct
orientation to ensure maximum load bearing capacity
(Ex. 10).
UP
Ex. 7
STEP 8
BACKFILL SIDES
• The excess excavation along the outside perimeter of the
storage basin can be backfilled once all of the AquaBlox
are installed. Use sand or compactible, free draining
material to backfill evenly on all sides, securing the
AquaBlox into position (Ex. 11).
Ex. 8
☎
☎
US (866) 877-6637 |
Proper Orientation
CAN (866) 766-3426 | aquascapeinc.com
Ex. 9
UP
Ex. 10
Publicité
