ADEUNIS LoRaWAN Guide Utilisateur page 47

FIELD TEST DEVICE - LoRaWAN Europe - Guide utilisateur / User guide version V2.0.0
Range
S226 LORA APP_sKEY (First section)
S227 LORA APP_sKEY (Second section)
S228 LORA APP_sKEY (Third section)
S229 LORA APP_sKEY (Fourth section)
S231 "Integrated antenna" mode
S280
S281
S201: SF value
The range allows you to set a "Spreading Factor" (SF) value to use when the device has not been configured with "Adaptive Data Rate" (ADR).
This value will then be used to transmit the frame on the LoRaWAN network. When the ADR is active, the SF will automatically be managed by
the network.
S205: Power value
The range allows you to set a "Transmission power" (dBm) value to use when the device has not been configured with "Adaptive Data Rate"
(ADR). This value will then be used to transmit the frame on the LoRaWAN network. When the ADR is active, the power will automatically be
managed by the network.
S214 and S215: LORA APP_EUI
The S214 and S215 ranges determine the APP_EUI key used during the JOIN phase in OTAA mode. The key is made up of 16 characters spread
across these 2 ranges, which can each contain 8 characters. The S214 range contains the start of the key, while the S215 range contains the end
of the key.
Example : 0018B244 41524632
S214 = 0018B244
S215 = 41524632
S216 to S219: LORA APP_KEY
The ranges from S216 to S219 determine the APP_KEY used during the JOIN phase in OTAA mode. The key is made up of 32 characters spread
across these 4 ranges, which can each contain 8 characters. The S216 range contains the first 8, the S217 range contains the next 8, the S218
range contains the next 8 and the S219 range contains the last 8.
Example : 0018B244 41524632 0018B200 00000912
S216 = 0018B244
S217= 41524632
S218 = 0018B200
S219 = 00000912
S220: ADR activation
If the ADR mode has been activated, the device will have no control over the SF and the Power because the parameter can only be modified by
the network. If the ADR has been deactivated, the SF value and power value used are that contained in the S201 and S205 registers.
Content
NETWORK ID
DEVICE ADDRESS
Default value
0
0
Parameter with 16 bytes. Each of the 4 ranges con-
tains 4 bytes.
0
0
0: deactivated
0
1: activated
0 Read-only
Comments
Page 47 of 50
FR
EN