Publicité
•
Remove all residual oil from the machine.
•
Remove the battery pack from the machine.
•
Clean all unwanted material from the machine.
•
Make sure that the storage area is
•
Not available to children.
•
Away from agents which can cause corrosion, such as
garden chemicals and de-icing salts.
11
TROUBLESHOOTING
Problem
Possible cause
The machine does
The poles are not
not start.
assembled cor-
rectly.
The lock-out but-
ton and trigger are
not depressed at
the same time.
The bar and chain
Oil tank is empty. Fill the oil tank.
gets hot and
smokes.
The discharge
port is blocked.
Inlet opening of
inner oil tank is
blocked.
The sprocket is
stuck and clogged
with debris.
The bar and chain
The chain tension
gets too hot and
is too tight or too
can not cut.
loose.
The chain is dull
The chain is put
on backwards.
English
Problem
The motor runs,
but the chain does
not cut correctly,
or the motor stops
after around 3
seconds.
12
Solution
Assemble the
Guide bar length
poles according to
the instructions.
13
1. Push and hold
the lock-out
button
2. While you
hold the lock-
out button,
pull the trig-
ger.
3. Release the
lock-out but-
Greenworks hereby warranties this product, to the original
ton to start the
purchaser with proof of purchase, for a period of three (3)
machine.
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion, will repair or replace any
and all parts found to be defective, through normal use, free
1. Remove the
of charge to the customer. This warranty is valid only for
battery pack.
units which have been used for personal use that have not
2. Remove dirt
been purchased or rented for industrial/commercial use, and
from the dis-
that have been maintained in accordance with the instructions
charge port.
in the owners' manual supplied with the product when new.
1. Clean the oil
tank.
ITEMS NOT COVERED BY WARRANTY:
2. Fill with clean
1. Any part that has become inoperative due to misuse,
bar and chain
lubricant.
1. Clean the
2. The unit, if it has not been operated and/or maintained in
sprocket.
2. Fill with clean
3. Normal wear;
bar and chain
4. Routine maintenance items such as lubricants, blade
lubricant.
Refer to Adjust
5. Normal deterioration of the exterior finish due to use or
the Chain Tension
in the manual.
Sharpen or re-
HELPLINE:
place the chain.
Warranty service is available by calling our toll-free helpline
Take out the chain
at 1-888-909-6757.
and turn it in the
right direction.
TRANSPORTATION CHARGES:
Transportation charges for the movement of any power
equipment unit or attachment are the responsibility of the
11
Possible cause
When you use the
machine under
load, it stops.
The chain is not
lubricated.
TECHNICAL DATA
10'' (254 mm)
LIMITED WARRANTY
3
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
accordance with the owner's manual; or
sharpening;
exposure.
Solution
1. Release the
trigger.
2. Start the ma-
chine again.
Lubricate the
chain to decrease
the friction.
YEAR
ANS
AÑOS
EN
Publicité
