Publicité
IMPORTANT: If the remote control is lost, or if the remote control needs to be replaced due to
technical problems, the coding must be carried out.
- The following operation should be prepared before coding:
1 – Disconnect the power supply of the receiver.
2 – Remove the battery of the trasmitter.
- Coding operation steps are as follow:
- Press and hold down the "UP" button and "STOP" button, and fill the battery into the battery
compartment of the trasmitter, until the LED red light of the trasmitter flashes rapidly, then release the
button;
- When the receiver is connected to the power supply, the LED red light of the trasmitter changes fast
flash to slow flash.
- At this time, the trasmitter and receiver are in state of code allocation.
- If the trasmitter encoding and channel number need to be sent to the receiver, the code allocation
operation can be completed by pressing "UP".
- To send the receiver code and channel number back to the trasmitter, simply press the "DOWN" key
to complete the coding operation.
- After successful coding, the LED green light of the emitter flashes once.
DE
Publicité
