Publicité
OPERATING INSTRUCTION
Flame speed Function(Remote Control Only)
Press the FLAME SPEED ICON to display the current flame speed setting.
Press the FLAME SPEED ICON again to scroll down through the flame speed settings: 1,2,3,4,5.
Heater Function
This heater has a thermostat sensor to control the ambient temperature in the surrounding area of the fireplace. The
heater will cycle ON and OFF to maintain the selected temperature. The thermostat setting range is 62ºF (17°C) to
92°F (32°C) and oF(OFF).
Hold down the Heater Function ICON for 5 seconds to toggle between Fahrenheit and Celsius. "F" or "C" will be
displayed on the control panel (°F/°C can only be toggled from the control panel and will not work if using the remote
control).
Timer Function
The timer setting should be used to set the countdown for the unit's main power.
Press Timer icon to adjust the timer setting:
A
B
C
D
E
Brightness Function(Remote Control Only)
The flame brightness mode should be used to set the flame birghtness:F5, F4, F3, F2, F1.
Heater Up(Remote control only)
Use the Up arrow to adjust the temperature according to the following rules:OF,62ºF(17°C),64ºF(18°C),66ºF(19°C)...
88ºF(30°C),90ºF(31°C),92ºF(32°C),ON.
Heater Down(Remote control only)
Use the Down arrow to adjust the temperature according to the following rules:ON,92ºF(32°C),90ºF(31°C),88ºF(30°C)
...66ºF(19°C),64ºF(18°C),62ºF(17°C),OF.
,1H,2H,3H,4H,5H,6H,7H,8H,9H,OF.
F
G
Power
A
Flame color
B
Flame brightness
C
Flame speed
D
E
Timer
F
Heater Up
G
Heater Down
PAGE 9 OF 12
1. The battery compartment is located on the back end of the remote
control.
2. Press and slide the battery door open.
3. Insert 2 AAA batteries, checking that the + and - sides of the battery
match inside the battery compartment.
4. Replace the batte
ry compartment door.
5. Batteries are not included in the package due to safety transportation.
Note:
Battery disposal
Please always dispose of batteries
at a suitable recycling point.
Publicité
