Publicité
CARE AND MAINTANCE
♦
Make sure the unit is turned OFF, unplugged and the heating elements of heater are cool
whenever you are cleaning the heater.
♦
Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or
household cleaners as these products will damage the metal trim.
♦
The motors used on the fan and the flame generator assembly are pre-lubricated for
extended bearing life and require no further lubrication. However, periodic
cleaning/vacuuming of the fan/heater and air intake/output vents is recommended.
♦
Any other servicing should be performed by an authorized service representative.
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or rewiring of
this unit should be carried out by a licensed electrician in accordance with national and local codes.
WARNING: If repairing or replacing and electrical component or wiring, the original wire routing, color
coding and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a qualified
service technician to inspect te fireplace and replace any part of the electrical system.
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of
fire, electrical shock or personal injury.
WARNING: During any service of this appliance, the power to the unit must be turned off. First turn
the main power switch to the "OFF" position. Then remove the electrical plug from the wall outlet.
WARNING: When the heater is not in use, the heater should be stored in a dry location, away from
possible damage. The power cord should be stored properly to avoid contact with hot or sharp objects.
Replacing the Remote Control Battery
When the remote control stops operating or its range seems reduced, it is time to replace
the batteries.
1.
The battery compartment is located on the back of the remote control.
2.
Press the small tab inward as you slide the battery door open and remove the old battery.
3.
Insert two new AAA battery (not included), ensuring the polarities of the battery match the inside
of the battery compartment.
4.
Re-insert the battery door.
NOTE:
♦
The batteries should be removed if the product is to be left unused for a long time.
♦
Do not mix old and new batteries.
♦
Do not mix alkaline, standard (carbonzinc), or rechargeable (nicad, nimh, etc) batteries.
♦
Non-rechargeable batteries are not to be recharged. Exhausted batteries are to be removed
from the product.
PAGE 10 OF 12
Publicité
