Publicité
CARE AND MAINTANCE
Disposal of Used Battery
A battery may contain hazardous substances that could be endangering
to environment and human health.
♦
This symbol marked on the battery and/or packaging indicates that used
battery shall not be treated as municipal waste. Instead it shall be left at
the appropriate collection point for recycling.
♦
By ensuring the used battery is disposed of correctly, you will help
prevent potential negative consequences for the environment and human
health. The recycling of materials will help to conserve natural resources.
TROUBLE SHOOTING GUIDE
PROBLEM
1. No power, logs
do not glow.
2. E1 displayed on
control panel.
3. E2 displayed
on control panel.
4. E3 displayed
on control panel.
5. Fan motor
continues to blow
after unit is
powered off.
6. Power cord
gets warm to the
touch.
7. PCB crashed.
POSSIBLE CAUSE
1. The unit does not have power.
2. The overheat protection device
has been engaged.
3. The ambient temperature sensor
is broken or not working correctly.
4. Heater lock function activate.
5. Normal operation.
6. Normal
operation.
7. No function operates, machine
does no response and alarm alerts.
1. Check that unit is plugged into a standard
120 volt outlet. Then make sure power is set
at "ON" position.
2. Unplug unit, wait 5-10 minutes, then the
sensor will reset itself. Plug the unit back in
and turn on the heater. If the problem
persists, call customer service.
3. Unplug unit, wait 5-10 minutes, then the
sensor will reset itself. Plug the unit back in
and turn on the heater. If the problem
persists, call customer service.
4. To inactivate the Heater Lock function,
hold the Heater Lock button for 10 seconds.
5. This is a standard feature; the blower runs
for an additional 20 seconds to ensure heat
will not be trapped inside the unit.
6. This is normal for a heater appliance as it
requires more current to operate. Check the
connections of the appliance cord and the
outlet. Make sure the plug fits tightly into the
outlet. During use, check the plug and outlet
frequently to determine if it is HOT; if so,
discontinue use of the appliance and consult
with a qualified electrician to check or change
the overheating outlet(s).
7. Frequently use on/off button repeatedly will triger the
PCB protection, unplug unit and wait for 5-10 minutes, then
the sensor will reset itself.
PAGE
OF
SOLUTION
Publicité
