Publicité
• Don't violently remove the short-circuit plug before the arrow on the rotating ring is
aligned with the arrow on the panel.
Screw hole
Cable guard cover
3
Pin
Step 1: Connect grounding cable to the inverter;
Step 2: Plug the negative power cable to connect: "BAT+" port of the BMS and the "BAT+" port of the inverter;
Step 3: Plug the negative power cable to connect: "BAT-" port of the BMS and the "BAT-" port of the inverter;
Step 4: Plug the communication cable to connect: "BMS" port of the BMS and "BMS" port of the inverter.
Power cable (-)
5
Screw hole
Rubber seal
cable entry
Pin
Pin
Power cable (+)
Click
BAT+
B -
AT
Grounding cable
BMS
Rotation wrench
NOTICE!
4
BMS
A
BMS
COM B
HEAT
Communication cable
Rear side of BMS
CAUTION!
• The end of the communication cable shall be closed
by using a rotation wrench.
B
91
Publicité
