Publicité
Rear side
Front side
NOTE: The side with "R" shall be against the wall.
2
The recommended distance between
the product and the wall is 100 mm.
Draw location
4
80 to 100 mm
Place a spirit level to check whether the Base is even.
If yes, refer to the step 4; if no, refer to the step 3.
NOTE:
Turn clockwise, raise the Base.
Turn anticlockwise, lower the Base
1
3
3
NOTE:
1.
Please make sure that the corners and edges of the
Base and battery pack are aligned before tightening
screws.
2.
It is recommended to insert and secure the screws
on one side, and then fully tighten them after the
screws on the other side are fully tightened.
5
2
4
81
Publicité
