Publicité
UK
DE
CN
FR
ES
4.4 Loudspeaker Rotation – Using the Compass
When the grille is removed you can see a compass ring round the edge of the
loudspeaker bezel, which can be used to read out the rotation of the loudspeaker
relatively to, for example, a fixed line on the ceiling. The tweeter is slightly o -center
and should be positioned so it is closest to the main listening position (see figure 7).
The PHANTOM E-60 S incorporates a compass ring around the edge of its bezel
(see figure 7B), that can be used to read out the rotation of the loudspeaker relative
to, for example, a fixed line on the ceiling. The tweeters should be positioned so they
are closest to the main listening position.
4.5 Connection of Cables/Selection of Cables
Your choice of cables is a crucial element in your installation. Be aware that replacing
cables a er installation is a di cult task. Therefore, select quali cables from the
beginning. Please consult your authorized DALI dealer for further advice on which
cable to select.
When connecting the cable to the loudspeaker and the amplifier, it is important that
the loudspeaker is connected in correct phase. The red (+) loudspeaker terminal
must be connected to the red (+) amplifier terminal. The black (-) loudspeaker
terminal must be connected to the black (-) amplifier terminal. If the loudspeakers
are not connected in correct phase, the soundstage will pically be di use and the
bass will be weak.
Additionally for the E-60 S, the stereo (le and right) cables require connection
to the correct terminals. Connect the le channel cable to the terminals on the
side marked "L" on the product label, and connect the right channel cable to the
terminals on the side marked "R".
To insert the cable end into the spring loaded terminals of the loudspeaker, remove
cable insulation so that approximately ½" / 12 mm of bare wire is exposed. Press the
top of the terminal down and insert the bare wire into the opening. When the wire is
fully in place with no loose strands exposed, release the terminal. The cable is now
connected. Please refer to figure 8 for correct cable connection.
5 . 0 C U T - O U T T E M P L AT E
The enclosed cut-out template (see figure 9) can be used to initially visualize how
your loudspeakers should be mounted and for marking where the cut-out should be
made. Tape the template at the preferred mounting position, so that you can mark
the necessary opening. The minimum mounting depth for the DALI PHANTOM E/E
WR models can be found in the Technical Specifications.
6 . 0 I N S TA L L AT I O N
Please study and follow the safe guidelines found in chapter 2.0 of this manual! Use
a trained professional to ensure that all safe requirements are met to prevent the
loudspeaker from falling.
The following tools and items are necessary for proper installation:
11
Publicité
