Abus TVCC80000 Mode D'emploi page 31

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 51
4. Installation
Before starting:
Check the scope of delivery and ascertain that the Speed Dome is not damaged.
Never hold the Speed Dome by its waterproof cable, as otherwise its water retardant properties
could be compromised.
4.1 Installation on the wall TVCC81100
1. Undo both the locking screws on the side of the Speed Dome and then open the dome.
2. Remove the lens protector, the foam and the adhesive strips from the dome.
Lens protector
Foam
3. Remove the speed dome using the two securing springs at the side.
4. Configure the dome address, baud rate and other settings using the SW 1 and SW 2 DIP switches,
see description, point 3).
As the speed dome adapts automatically to PELCO-D and PELCO-P no setting with regard to
the protocol is required here.
31
English
Locking screw
Adhesive strips

Publicité

Table des Matières
loading

Table des Matières