Publicité
TESTING AND COMMISSIONING
––– PHASE 7 –––
CAUTION! – The operations described in this chapter must be
carried out exclusively by qualified personnel, in accordance with
these instructions and with the local safety regulations in force
7.1 - TESTING
Ensure that all the instructions and warnings indicated in Chapter
1 have been strictly observed.
Use the push-button panel to control the opening and closing movements
of the shutter, while verifying the following aspects: a) the shutter's up-
ward and downward movements must match the direction of the arrows
appearing on the buttons of the control push-button panel; b) the motor
must stop the shutter automatically in the points set for the limit switches;
c) the shutter must move in a smooth and fluid manner, without any fric-
tion points.
7.2 - COMMISSIONING
The automation can only be commissioned once all the testing
phases have been successfully completed. Partial or "makeshift"
commissioning is strictly forbidden.
Prior to commissioning the automation, the owner must be adequately
informed on its operation, on the hazards and risks still present and on
the importance of periodically inspecting its parts to prevent malfunctions.
WHAT TO DO IF...
(guide to problem resolution)
The motor does not move even though the power supply is pres-
ent:
– check whether the thermal protection has been activated: in this case,
it is sufficient to wait until the motor cools;
– check the presence of the mains voltage and the correspondence be-
tween the measured values and the engine plate data, by measuring
between Common and the electrical phase supplied; to finish, try sup-
plying the opposite electric phase;
– check whether the two limit switches, due to incorrect adjustment, ac-
tivate at the same time; in this case, turn the two adjustment screws a
few turns in a clockwise direction (+).
If, at the end of these checks, the motor persists in not moving, there is
probably a serious failure.
MAINTENANCE
Maintenance must be performed in strict observance of the safety
provisions in this manual and according to current legislation and
standards.
The automation's devices do not require special maintenance; however
they should be checked periodically (at least every six months) to ensure
their full efficiency.
6 – English
PRODUCT DISPOSAL
This product is an integral part of the automation system and must
therefore be scrapped with the rest of the latter.
As for installation, at the end of the life of this product, the dismantling
operations must be carried out by qualified personnel.
This product is made from various materials: some may be recycled, oth-
ers must be scrapped. Research the recycling or disposal systems pro-
vided by the standards in force in your country for this product category.
CAUTION! - Some components of the product may contain
polluting or hazardous substances which could, if disposed of in
nature, have harmful effects on the environment and on people's
health.
As indicated by the symbol shown, it is forbidden to discard
this product in household refuse collection facilities. Sort the
components, to ensure their elimination in accordance with lo-
cal standards in force, or return the product to the seller when
purchasing a new equivalent product.
CAUTION! – The local regulations in force may impose heavy
penalties in the event of illegal disposal of this product.
TECHNICAL CHARACTERISTICS
WARNINGS: • All technical characteristics shown refer to an ambient
temperature of 20°C (± 5°C) • Nice S.p.a. reserves the right to make
changes to the product when it deems this necessary, whilst guaran-
teeing the same functions and usage for which the product is intended.
• Power supply voltage and frequency; Current and power;
Torque and speed: See technical data on the label on the motor
• Motor body diameter: 45 mm
• Continuous operation nominal duration:
maximum 4 minutes
• Degree of protection: IP 44
• Minimum operating temperature: -20°C
Publicité
