Publicité
INSTALLATION: COMPONENT ASSEMBLY AND CONNECTION
––– PHASE 3 –––
3.1 - AUTOMATION COMPONENTS INSTALLATION
The installation operations described in this phase may also be carried out
by unqualified personnel, provided that they comply scrupulously and in
the order indicated, with the instructions given.
Caution! - Improper installation may cause serious injury to the
person who performs the work and to those who will use the in-
stallation.
01a. Thread the octagonal crown over the motor tube and push it, as far
as the motor head (fig. 6a). Important – slide the crown groove into
the protrusion found on the bushing of the limit switches.
6a
01b. Fit the drive wheel to the self-locking mechanism on the motor shaft,
by matching up the two arrows on the two devices (fig. 6b). Note
- if you wish to disconnect the wheel, press the "Push" button and
extract it.
6b
• Measure the motor as shown in fig. 6c.
6c
01c. (fig. 7) Align the adapter groove (a), with that on the drive wheel (b).
Then insert the motor into the roller tube, by sliding the two grooves
a and b in relation to the protrusion (c) found inside the roller tube.
7
01d. (fig. 7a) Screw the supplied screw into the tube (self-tapping 3.9 x
13, UNI 8118) at the point where the drive wheel is located inside
the tube (use the measurement carried out in fig. 8c). This step ena-
bles the wheel to be correctly locked with the tube.
Caution! - To determine the exact point to place the screw,
measure as shown below.
7a
10 mm
02. Install the tube (with the motor) on the supports as follows:
a) – fix the motor head to the support (fig. 8a);
b) – finally, at the other end of the tube, slide the roller into the sup-
port interior (fig. 8b).
2
03. Carefully position and affix the power cable to the inside of the case,
in its final position. Caution! - Inside the case, the power cable must
M
8
1
English – 3
a
b
Publicité
