Installation manual
Starting up
3.4.
3.4.1
Fill the filter with water half way to proceed with the filling.
3.4.2
Place in the filter selector valve, the tab in the washing position, activate the filtering
pump by hand and wash it for approximately 2 minutes, stop the pump and place the
tab in rinse position, activate again the pump and rinse for 15 seconds approximately.
3.4.3
Stop the pump and change the tab into the position of filtering. Refill the Spa again
following the indications in section 3.2.6 of Connection.
3.4.4
Programme the thermostat to the desired temperature. (Reaching the desired
temperature after the filling of the Spa can take several hours).
3.4.5
Programme the filtering clock. (Read the operation cabinet manual).
3.4.6
Activate in the Operation Cabinet the massage and heating switch. Place the filtering
switch in the desired position to make the Spa start operating, starting the filtering and
heating cycles.
3.4.7
Once all this has been checked, fill in the guarantee sheet attached to the product and
send it back to the manufacturer.
12
English