Connection - Astralpool Caratula Spa Obra R1.0 Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
Installation manual
3.3.

Connection

3.3.1
Make the connection between the Spa and the filtering, heating and massage
equipment with a rigid pipe and install antireturn valves in all circuits.
3.3.2
Remember that in the Spa connections with fittings there are adhesives indicating the
type of circuit and the direction of the water flow.
3.3.3
Always keep the main differential in the OFF position, connect the equipment to
the operation box and that to the electric power, always checking the voltage. Reading
the manuals attached to the Compact Kit is essential.
Electric box manual for Public use compacts.
Installation and Maintenance Manual for Private Use Compacts.
3.3.4. Open all equipment valves except the drainage one.
3.3.5. Clean the Spa surface to avoid any particle being absorbed by the components or
circuits and block them.
3.3.6. Fill the Spa up to the level indicated on the label placed in the skimmer area. Water
must not be below this level.
In case of Spa with overflow and compensation deposit, fill the Spa once the Spa filling
valve has been opened, until water surpasses from 5 to 8 cm the probe nº 2 of the
compensation deposit.
Important: When starting up for the first time the filtering equipment, the water level
in the deposit will clearly decrease. This happens because the pipe going from the
compensation deposit to the Spa, the filter and the pump are filled with air.
3.3.7. Wait 15 minutes and check all connections, to verify any kind of leak in the pipes.
3.3.8. Connect the box to the electric power (main differential in position ON).
3.3.9. Start up the filtering, massage and air pump and check any pipe leaking and joint
connections 30 minutes after operating.
11
English

Publicité

Table des Matières
loading

Table des Matières