Publicité
MANTEL LOCATION
When choosing a location for your new fireplace
be sure that the general instructions are followed.
Also, for best effect, install the fireplace out of
direct sunlight.
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, 60 Hz circuit with a properly
grounded outlet is required. Preferably, the
fireplace will be on a dedicated circuit as other
appliances on the same circuit may cause the
circuit breaker to trip or the fuse to blow when the
fireplace is in operation. The unit comes standard
with 6 feet (1.8 m) three wire cord, exiting from the
rear of the heater.
CAUTION: Avoid the use of an extension cord
because the extension cord may overheat and
cause risk of fire. However, if you have to use
an extension cord, the cord must be No.14 AWG
minimum size and rated not less than 1,875 watts.
The extension cord must be a three-wire cord with
grounding type plug and cord connection. The ex-
tension cord shall not be more than 20 ft. in length.
SAFETY INFORMATION
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs
or rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
If repairing or replacing any electrical component or wiring, the original wire routing,
color coding and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this heater if any part of it has been under water. Immediately
call a qualified service technician to inspect the heater and replace any part of the
electrical system.
Warning: Disconnect power before attempting any maintenance or cleaning to reduce the
risk of fire, electrical shock or personal injury.
Warning: During any service of this appliance, the power to the unit must be turned off.
First turn the main power switch to the "OFF" position. Then remove the electrical plug
from the wall outlet.
All manuals and user guides at all-guides.com
Keep electrical cords, drapery, furniture and other
combustibles at least 3 feet (0.9 m) from the front
and sides of the heater.
Clean the trim using a soft cloth, slightly dampened
with citrus oil based product and buff with a clean
soft cloth. DO NOT use brass polish or household
cleaners as these products will damage the metal
trim. Citrus oil based products can be obtained at
supermarkets or hardware stores.
ELECTICAL SPECIFICATIONS
4
CLEARANCE TO COMBUSTIBLES
CLEANING TRIM
Voltage
120 V~, 60 Hz
Amps
12.5 Amps (with heater)
Amps
<0.1 Amps (without heater)
Watts
1500 Watts (with heater)
Watts
<10 Watts (without heater)
Publicité
