Publicité
G.
Holiday Mode (requires 78EV wall control):
Portable remote controls do not function if this feature is activated�
H.
Operator light control (requires 78EV wall control):
The operator light can be switched on and off at any time.
Automatic lighting (only with light barrier and wall bracket) When
the light barrier is interrupted, the lighting automatically switches
on during the opening of the door� Activation: Press and hold the
"LIGHT" button on the wall bracket for 10 seconds� Deactivation:
see activation�
I.
Keyless entry (requires 780EV wireless keypad):
Enter a 4 digit code of your choice to operate the door�
J.
Temporary access (requires 780EV wireless keypad):
A temoprary code can be programmed to allow limited acces to the
garage (by time or number of openings)�
K.
One button close feature (requires 780EV wireless keypad):
Without having the access code the door can be closed from any
position (not opened)�
L.
myQ (requires 828EV gateway):
Allows operating your garage door opener via smartphone or
tablet connected to internet�
M.
Safety edge (only with ADP-1EVO).
Enables the garage door opener to be operated with a safety
edge (8�2k Ohm)� The taught-in operating force of the garage door
opener is automatically increased�
Attention: only valid with approved safety edges�
N.
myQ LED light.
The myQ LED light (827EV) can be programmed with the garage
door opener for additional lighting�
O.
Power supply for external devices (terminal 30V)
30VDC/max� 50mA
Note: For external (universal) receivers, the under 1 watt standby
mode must be turned off.
P.
Turning on/off the under 1 watt standby mode
The under 1W standby mode is always switched on at the factory�
(After the lights go off and with the garage door closed.)
Switch off under 1 watt standby:
1� Disconnect device from the mains�
2� Press the UP and DOWN buttons on the back on the adjusting
panel simultaneously and hold�
3� Connect the device again while the buttons are still pressed�
4. After about 5 seconds the opener's light flashes 10 times as
confirmation.
Note: Every time the opener is disconnected from the
mains, the opener's light flashes 10 times during reconnection to
indicate that the under 1 watt standby mode is off.
Switch on under 1 watt standby: See activation
Q.
Cycle counter
This garage door opener features a cycle counter
(open/close = 1 cycle)�
1� Pull plug�
2� Simultaneously press and hold round and sqare button on the
backside of the opener�
3� While holding the buttons insert plug�
4� After approx� 5 sec the UP button indicates the number of cycles
(for every 1000 cycles the UP button flashes once). Release
buttons�
28
Operation of the door opener
Automatic opening / closing of the door:
The door opener can be operated using the following devices:
• Remote control: Press the button until the door starts to move�
• Wall switch (if this accessory is installed): Press the pushbutton until
the door starts to move�
Manual opening of the door (by hand):
If possible, the door must be closed completely� Weak or
defective springs can cause a rapid shutting down of the
open door, which can lead to property damage or serious
personal injury.
RELEASE: Briefly pull the red handle down. Then open the door by
hand� Open close door without pulling the cable!
RECONNECT: The lockout feature prevents the trolley from reconnec-
ting automatically� Push the green button on the trolley� With the next
door movement the system will reconnect�
en 9
Publicité
