LENCO CR-615 Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

DAB/DAB+ Menu
1.
In DAB mode, hold down the "MENU/INFO" button (5) for a few seconds.
2.
Turn the "VOLUME/SCROLL/ENTER/SNOOZE" dial (6) to select the desired item from:
Full Scan, Manual tune, DRC, Prune, TA, System.
3.
Press the "VOLUME/SCROLL/ENTER/SNOOZE" dial (6) to select the desired item and
enter its settings.
A) Full Scan – Automatically scan DAB+ stations
B) Preset Recall - select a radio station from those stored.
C) Preset Store - allows you to store a station.
D) Manual Tune – manual tune
E)
DRC – off, low, high. When activated, DRC reduces the volume of louder sounds and
boosts the volume of quieter sounds. Good when you listen at low volume.
F)
Prune – yes, no. when activated, the stations with no signal will not be shown anymore
on the display.
G) TA - On, Off. This function is traffic info.
H) System –
1.
Sleep – off, 15, 30, 45, 60, 90 (minutes)
2.
Alarm - To set Alarm 1 and Alarm 2.
3.
Time:
Set Time/Date
Auto update - Automatic update of date and time from source or Off.
It is advisable to keep it set to "Update from DAB" to avoid continuous
time shifts.
Set 12/24 hour - Set AM/PM or 24-hour.
Set date format - DD MM YYYY, MM DD YYYY
4.
Language – English, Deutsch, Italiano, Francais, Nederlands, Espanol, Dansk,
Portugese.
5.
factory reset – No or Yes
6.
SW version
FM Radio
Automatic Station Memory
1.
Press and hold for 3 seconds "PRESET SCAN" button (4) to start scanning and automatic
preset of the stations.
2.
At the end of the scan, use the "P+/TUNE+" button (7) or "P-/TUNE-" button (8) to
select a memorized radio station.
Note: The automatic scan sensitivity is adjustable by Menu.
Manual search and storage:
1.
Press and hold the "P+/TUNE+" button (7) or "P-/TUNE-" button (8) for a few seconds to
tune in to the next or previous radio station.
2.
To store a radio station:
Move to the frequency to be stored and press the "PRESET SCAN" button (4).
Turn the "VOLUME/SCROLL/ENTER/SNOOZE" dial (6) to select the number
where to store the station.
Press the "VOLUME/SCROLL/ENTER/SNOOZE" dial (6) to confirm.

Publicité

Table des Matières
loading

Table des Matières