Jet Tools JTS-315LA-M Mode D'emploi page 7

is mounted on the left front side (see Fig 1 & Fig 3).
Screw the side struts (O) and legs (J) loosely together.
Mount the diagonal strut (U) as shown in Fig 3
Tighten all nuts.
Mount the rubber feet (P) on the legs.
Install dust port:
Fasten the dust port (S, Fig 4 to the bottom of the chip box (Q)
with 4 screws (X).
Install wheels:
Mount the wheel supports (22, Fig 5) to the rear legs (J) with
screws (33).
Fig 3
Fig 4
Turn the saw upside down and place it on the legs.
Install floor brackets:
Mount floor brackets (a, Fig 6) to the legs (J) with screws (b).
This allows bolting the machine to the floor.
Install switch:
Insert the switch (C, Fig 7) into the leg opening and fasten
with 2 screw s (C1).
Install saw blade:
See chapter 7.1
Fig 5
Fig 6
Fig 7