Adjusting Sawblade Parallel; Maintenance And Inspection; Troubleshooting - Jet Tools JTS-315LA-M Mode D'emploi

If out of alignment:
Disconnect saw from the power source, unplug.
Readjust the stop screw (W, Fig 25).
7.7 Adjusting sawblade parallel
The sawblade is adjusted parallel to the machine table at the
factory.
If out of alignment:
Disconnect saw from the power source, unplug.
Loosen the screws on the table top (V, Fig 26) and readjust
saw unit.
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair work may only be carried
out after the machine is protected against accidental starting
by pulling the mains plug.
Repair and maintenance work on the electrical system may
only be carried out by a qualified electrician.
Consult a qualified repair shop if a malfunction or damage
occurs to this tool, including sawblades and guards.
Cleaning:
Clean the machine regularly.
Inspect the proper function of the dust extraction daily.
Keep the inside of the cabinet clear of sawdust and wood
chips.
Fig 25
Fig 26
All protective and safety devices must be re‐attached
immediately after completed cleaning, repair and
maintenance work.
Defective safety devices must be replaced immediately.
Saw blades:
The servicing of saw blades should only be performed by a
trained person.
Defective safety devices must be replaced immediately.
Check saw blades regularly for faults. Replace a defective
sawblades immediately.
Motor Break:
The motor break works electro‐mechanically (break motor).
If breaking time should exceed 10 seconds, the motor break
assembly needs to be replaced. Contact your Jet service
station immediately.
9. Trouble shooting
Motor doesn't start
*No electricity‐
check mains and fuse.
*Defective switch, motor or cord‐
consult an electrician.
Machine vibrates excessively
*Stand on uneven floor‐
adjust stand for even support.
*dust on saw flanges‐
clean saw arbor and flanges.
*defective sawblade ‐
replace sawblade immediately
Cut is not accurately square
*90° stop not adjusted correctly‐
check with square and adjust stop.
Material binds blade when ripping
*Rip fence not parallel to sawblade‐
check and adjust rip fence.
*Wrapped wood‐
select another piece of wood.
*Excessive feedrate‐
reduce feedrate.
Material kicked back from blade
*Fence not aligned with sawblade‐
check and adjust rip fence.
*Raving knife not in place‐
high danger, mount immediately with guard.
Cutting surfaces is bad
*Wrong sawblade used
*Blade mounted backwards
*resin collection on sawblade
*sawblade is dull
*work piece inhomogeneous