Publicité
FRONT AND REAR SUB-TABLE KIT
KIT PN 2876966
WARNING
Do not inverse the right and left sides.
Rear Anti-rotation Installation
3. Assemble the rear anti-rotation assembly following
these steps :
3.1. Screw the
5/8" nc
part of the anti-rotation tube (#3).
3.2. Install the
50mm O.D. X 17mm I.D. X 3mm
washer (#16) onto the threaded part of the anti-
rotation tube (#3).
3.3.
Install the bushing spacer tube (#4) onto the
threaded part of the anti-rotation tube (#3).
3.4. Install the rubber bushing (#2) over the bushing
spacer tube (#4).
Figure 11 - Rear anti-rotation assembly (steps 3.1 to 3.4)
3.5. Slide the anti-rotation assembly into the hole
on the bottom of the sub-table (#5).
3.6. Install the rubber bushing (#2) over the bushing
spacer tube (#4).
3.7. Install the
3/4" I.D. X 2" O.D. X 1/8"
(#15) over the bushing spacer tube (#4).
3.8. Install the rubber bushing (#2) over the bushing
spacer tube (#4).
3.9. Install the
50mm O.D. X 17mm I.D. X 3mm
washer (#16) onto the threaded part of the anti-
rotation tube (#3).
3.10.Screw the
5/8" nc
threaded part of the anti-rotation tube (#3).
Finger tighten only at this time.
2510235
A-2510235 (F-Polaris)
nut (#10) onto the threaded
flat
flat washer
flat
nylock nut (#13) onto the
Figure 12a - Rear anti-rotation assembly (steps 3.5 to 3.10)
Figure 12b - Rear anti-rotation assembly
- 9 -
Publicité
