Publicité
FRONT AND REAR SUB-TABLE KIT
KIT PN 2876966
Figure 6b - Orientation of the front sub-table clamping plate
4.3. Install the clamping block (#1) onto the sub-table
(#5) using the
3/8" nc X 2-1/2" (grade 5)
(#9), the
flat washer (#14), and the
3/8" dia
nylock nut (#12). Torque to 20 ft-lbs.
NOTE : Pay special attention to the orientation given to the
clamping block (#1) during installation. See Figure
7b.
Figure 7a - Front sub-table installation (step 4.3)
Figure 7b - Orientation of the clamping block
2510235
A-2510235 (F-Polaris)
4.4. Tighten the bolts (#8) installed in step 4.2. and
make sure they fit snugly. Torque to 20 ft-lbs.
Tighten in a manner not to permanently
deform the sub-table.
5. Reinstall the front CV shield removed during step 2
using the original hardware.
Front Anti-rotation Installation
(see Figure 2 - Table 2 (page 5) for the front anti-rotation
exploded view and the parts list)
6. Install the front anti-rotation assembly on the sub-
table following these steps :
6.1. Install the large ball joint spacer (#2) with the
carriage bolt
narrow part facing down onto the
3/8" nc
(grade 5)
NOTE : Pay special attention to the orientation
given to spacers (#2 and #4) during
installation. See Figure 8b.
6.2. Install the ball joint of the anti-rotation
assembly (#6) onto the bolt (#10), below the
large ball joint spacer (#2).
6.3. Install the short ball joint spacer (#4) with the
narrow part facing up, below the anti-rotation
assembly (#6).
NOTE : Pay special attention to the orientation
given to spacers (#2 and #4) during
installation. See Figure 8b.
6.4. Tighten the assembly with a
(#13). Torque to 65 ft-lbs.
Figure 8a - Front anti-rotation installation (steps 6.1 to 6.4)
- 7 -
carriage bolt (#10) installed in step 3.
1/2" nc
1/2" nc X 3"
nylock nut
Publicité
