Publicité
FRONT AND REAR SUB-TABLE KIT
KIT PN 2876966
Figure 8b - Orientation of the ball joint spacers
WARNING
If the bolts are not sufficiently tightened, there is a
risk of them becoming loose, of parts detaching and
risk of loss of control over the vehicle, as well as risk
of personal injury.
6.5. Rotate the anti-rotation assembly (#6) towards
the center of the ATV to prevent it from inter-
fering with the installation of the Track Kit (#7).
NOTE : Refer to the Track Kit manual for the correct
adjustment.
Figure 9 - Front anti-rotation installation (step 6.5)
Rear Sub-table Installation
(see Figure 3 - Table 3 (page 6) for the rear sub-
table exploded view and the parts list)
1. Raise the rear of the ATV off the ground and remove
the rear wheels.
2510235
A-2510235 (F-Polaris)
WARNING
When the ATV is raised, make sure that it is properly
secured/supported to prevent it from accidentally
falling during the installation of the tracks. If not
properly secured/supported, serious physical injury
could occur.
2. Install the sub-tables on the rear a-arm following
these steps :
2.1. Position the sub-table (#5) below the lower rear
a-arm.
2.2. Install the tightening plate (#6) over the rear
lower a-arm and fasten it to the sub-tables (#5)
using
(2) 3/8" nc X 1-1/2"
flat washers (#14), and
3/8" dia
nuts (#12).
2.3. Tighten all the bolts. Torque to 25 ft-lbs.
Figure 10a - Rear sub-table installation (steps 2.1 to 2.3)
Figure 10b - Rear sub-table assembly
- 8 -
carriage bolts (#9),
(2)
nylock
(2) 3/8" nc
Publicité
