Publicité
5
Installation of fan blade and fan guards
Remove any sleeving from the motor spindle.
Remove the four rear guard retaining screws from the motor
housing(9). Attach the rear guard (4) to the motor housing using the
four screws.
Place the fan blade (3) over the motor spindle (12) and tighten the
fan blade retaining screw (13) ensuring that it tightens against the
flat on the motor spindle(12).
Remove the nut & screw (5 & 2) from the front guard (1), turn the
clips around the outside edge of the front guard (1) outwards.
Hang the front guard (1) and fasten it to the rear guard (4).
Finally fit the nut (5) and screw (2) through the hole in the bottom
edge of both the guards and tighten with a screwdriver.
10
OPERATING INSTRUCTIONS
1.Set the fan on a dry, level and sturdy surface.
2.Plug the fan into the mains.
3.Be sure the voltage of the fan conformed to local power condition
before using it.
Oscillation, Adjusting Angle
1.Push down the oscillation knob to make the fan head oscillate,
and pull-up the oscillation knob to stop the fan head from oscillating.
2.Loosen the adjusting angle knob, adjust the fan to the desired
angle, to secure tighten the adjusting angle knob.
ON/OFF, Speed Selection
Adjust the desired speed by turning the power switch:
0--- Stop Ⅰ--- Low Ⅱ--- Medium Ⅲ--- High
CLEANING AND MAINTENANCE
Your fan requires little maintenance and contains no user
serviceable parts. Do not attempt to dismantle the Fan Motor body
yourself. The fan is permanently lubricated and will not require
additional lubrication.
Important: Do not allow water to run into the interior of the fan, as
this will cause an electric shock. DRY THE FAN THOROUGHLY with
a dry cloth, check that the fan is completely dry before operating the
fan.
Important Safety Instructions
When using electrical appliance, basic precautions should be
followed to reduce the risk of fire and personal injury.
11
Publicité
