Publicité
Assembly Instructions
1
6
15
Attach the telescopic stand (6) to the base (15) by placing the
weight (16) on the underside of the base (15) and the clamping
washer (17) in the centre of the weight. Thread the l-shaped screw
(18) through the assembly and into the thread in the telescopic
stand (6). Tighten firmly but do not over tighten.
2
19
7
6
Next, attach the motor housing (9) to the top of the telescopic stand
(6). First remove all the screws, etc. (7, 8, 19 & 20) from the motor
housing bracket.
08
17
18
16
9
8
19
8
20
7
3
Place the motor housing on the top of the stand and thread the large
pivot bolt (20) through the bracket and screw in the small retaining
screw (19) and tighten (but do not over tighten).
4
Fit the large pivot knob (7) onto the end of the bolt (20) and the tilt
adjusting knob (8).
Hold the fan motor upright and tighten the large pivot knob (7) and
the tilt adjusting knob (8).
19
20
8
19
20
7
09
Publicité
