Publicité
Remove from below the vehicle any protective sealant from the points of contact between the shell and the tow bar; then paint the
parts with rust preventer.
1.
Disassemble the side cladding (right and left) within the luggage compartment.
2.
Disassemble the rear lights.
3.
Disassemble the rear bumper, loosen the exhaust pipe support and disassemble the reinforcement cross bar.
4.
Cut from the reinforcement cross bar the piece of tinplate "X" where it's welded the pivot of the exhaust pipe support as
shown in the enclosed layout.
5.
Eliminate the reinforcement cross bar.
6.
Place the tow bar "A" in correspondence to holes "1", interject the pivot of the exhaust pipe support "X" just cut on the left
side and fix with the original nuts.
7.
Tighten all bolts and nuts with a tightening torque as shown in the enclosed layout.
8.
Connect the wiring to the socket (usually given apart), following the car booklet's instructions "use and maintenance" as
shown in the enclosed wiring kit layout.
9.
ONLY FOR MODEL 06030/C: Cut the plastic carter as shown in the enclosed layout.
10.
Reassemble the exhaust pipe support.
11.
Reassemble the bumper, the rear lights and the side cladding (right and left) within the luggage compartment.
•
Make sure that the tow bar is suitable for the vehicle before starting the installation. Verify also that the vehicle's towing
disposal quoted on the car registration is mentioned on the tow bar document. Otherwise ask for the appropriate office
(umbrarimorchi@umbrarimorchi.it) for explanations or updated documents.
•
For safety, all work involving tow bar installation must be undertaken by skilled technicians.
•
Damaged components must be replaced with manufacturer's spares parts by qualified staff.
•
It is forbidden to make any modification or structural repair to the tow bar.
•
The tow ball must be kept clean and lubricated. For added safety, his diameter (50 mm) must be checked at regular
intervals. If the tow ball measures less than 49 mm after selected readings across the diameter, the tow ball must be
replaced with a new one.
•
After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table.
FITTING INSTRUCTIONS
SAFETY INSTRUCTIONS
USE AND MAINTENANCE
06030 • 1.2 • 10/08/2022
6
Publicité
