Delta 50560 Serie Mode D'emploi page 29

3
Shower Head and Tub Spout Installation
A.
2
4
B-1 58045
2
1
B-2
B-1: To combine the two showers, insert the top tab (1) on the hand shower into the slot (2) of
the shower head. Push the hand shower into the shower head until the two parts snap together.
B-2: To combine the two showers, push the hand shower into the shower head, then pull down
on the hand shower until locked with the shower head.
If the shower head moves when removing the hand shower, hand tighten the connection between
the shower head and the shower arm.
To change spray modes, turn the lever (3) left or right to the desired setting. Turn knob (4) to
change between shower head only, shower head and hand shower or hand shower only.
FOR SHOWER HEAD INSTALLATION: Connect top
1
outlet (1) to shower arm (2) with proper fittings. To
prevent damage to finish on shower arm, insert wall end
of shower arm into shower flange (3) before screwing
arm into riser connection. Thread shower head (4) onto
3
shower arm. Apply plumber tape to pipe threads on both
ends. Do not overtighten shower head.
3
3
7
Installation
4
4
107528 Rev. F