Publicité
•
Loosen the latch hinges of the vacuum head (Fig.06) and remove it (Fig.07).
•
Fig.10).
N.B:
•
Empty the collection tank.
N.B:
•
Fig.08) and the vacuum head (Fig.09).
•
Start work again.
N.B:
Cleaning wet surfaces
1.
Fig.04).
2. Check that the plug on the power cable is connected to the power supply socket, otherwise
disconnect it.
WARNING:
Free the vacuum head (Fig.06
N.B:
4.
N.B:
5. Secure the vacuum head to the collection tank (Fig.09-10).
6. Plug the power cable into the mains socket.
ATTENTION:
7. Switch on the appliance by positioning the vacuum motor switch to position "I" (Fig. 4).
N.B:
8. Start work.
If when working a reduction in the vacuuming power is noted or the noise of the appliance becomes
•
•
Remove the plug from the power socket.
WARNING:
•
Loosen the latch hinges of the vacuum head and remove it (Fig. 6-7).
•
Empty the collection tank.
N.B:
•
Fig.13
•
Fig.12).
•
Reassemble the vacuum head (Fig.9-10).
•
Start working again.
Take the appliance to the designated machine storage place after work is completed.
ATTENTION:
EMPTYING THE COLLECTION TANK
At the end of the work, and before carrying out any type of maintenance, perform the following
1. Take the appliance to where its collection tank is emptied.
N.B
CAUTION
2.
Fig.04).
Check that the plug on the power cable is connected to the power supply socket, otherwise
disconnect it.
WARNING:
4. Free the vacuum head (Fig.06) and lay it on the ground.
5. Empty the collection tank.
N.B:
N.B:
6.
1. Take the device to its maintenance area.
CAUTION
2.
Check that the plug on the power cable is connected to the power supply socket, otherwise
disconnect it.
WARNING:
Fig.11).
4. Free the vacuum head (Fig.06) and lay it on the ground.
5.
6.
N.B:
Fig.12).
7.
8.
N.B:
9.
10.
PROBLEM
Fig. 4).
Fig.14).
11
MAINTENANCE
Fig.04).
Fig.11).
Fig.13).
TROUBLESHOOTING
POSSIBLE CAUSE
The main switch is not activated.
Press the main switch.
The plug on the appliance's power
Connect the plug on the appliance's
cable
has
not
been
correctly
power cable to the mains socket.
inserted into the mains socket.
Check that the technical data on
the appliance do not match the
the appliance's serial number plate
match the data of the mains supply.
supply network.
Contact a specialised technician
The power cable is damaged.
immediately.
The vacuum hose is not connected
Connect the vacuum hose correctly
correctly to the nozzle on the
to the nozzle on the collection tank.
collection tank.
The vacuum hose is not connected
Connect the vacuum hose correctly
correctly to the extension hose.
to the extension hose.
The
extension
hose
is
not
Connect
connected correctly to the vacuum
correctly to the vacuum accessory
accessory being used.
being used.
The vacuum circuit is blocked
Remove the obstruction in the
(vacuum hose; extension hose;
vacuum circuit.
vacuum accessory).
There is a blockage in the vacuum
Clear the obstruction in the vacuum
DISPOSAL
Fig.14).
SOLUTION
the
extension
tube
Publicité
